Finger puppets Snowmen

[cookie tlc]

I just down loaded the snowmen finger puppets. They are soo cute ! Can anyone tell me how they go together?? There is a front and a back but for the life of me I can see how they get sewn together.

thanks Cookie tlc

[marji]

Hi, Cookie,
I don't have these, but I looked at them and the stitch charts. My guess would be to stitch them out on white felt, cut them out making sure you leave enough seam allowance to stitch on, put right sides together, and stitch on your regular sewing machine.

I sure hope if someone has them they see your question. I also looked in the instructions on the home page of the website, zilch. You could submit a support ticked to "Help and Support", perhaps there are instructions that haven't been posted yet?

Good Luck to you,
Marji

[cookie tlc]

Thanks I was just hoping that it would have been a in the hoop project... I am going to have to make them since they are so darn cute

Thanks for the help and have a terrific day !! cookie tlc

[Cutiepie]

Hi, Cookie. Do you have a larger hoop than 4x4? What format do you use? Anyone who has a hoop larger than the 4x4 can use this outline to make the snowman finger puppets "in the hoop". It just has to be a touch larger than 4 inches high to go around the images.

To use this outline, all you need to do is stitch the front and back of your puppet on white felt, leaving the second part (whichever it happens to be) in the hoop. Place the first part behind the hooped part, right sides out, and line them up so that they match. DO NOT TRIM DOWN EITHER PIECE OF FELT at this time! Use pins to keep the loose piece of felt from moving and stitch the outline through all thicknesses. Then, unhoop the project and trim close to the outline stitching without cutting the stitches themselves, cutting straight across the open end. Ta-da, you have a puppet! I am designing a set of finger puppets for "Old MacDonald's Farm" that are done in the hoop in this fashion, and it works well.

[cookie tlc]

thanks so much I do have 6x10 capablities... So I will try this... My format is PES but I can convert so no biggie.....

thanks again for the help. Cookie tlc

[cookie tlc]

cutie pie
must be a little slow tonight I tried to download the file but all I get is some stitch out information any suggestions?? thanks

[pearlfromoz]

I went to d/l the outline for the snowman finger puppets, but only got a printout page. If possible can I get a d/l in either jef or pes please, :

[Cutiepie]

Huh . . . don't know why people aren't getting the design. I'm posting it again, this time in PES and JEF format. I hope it works better for you this time!

[pearlfromoz]

Thank you both have d/l fine thank you

[cookie tlc]

thanks cutiepie I was able to down load these as well. I finaly figured out how to d/l the other one.... instead of left clicking with the mouse I had to right click and then choose save target as..... never had to do that before....

Thanks for the extra posts..... I off to make snowmen !!!

Cookie tlc

[jand803]

Huh . . . don't know why people aren't getting the design. I'm posting it again, this time in PES and JEF format. I hope it works better for you this time!

I don't see any download files. Can you help me? Is this one of those cases where the d/l files didn't convert with the messages?

[Cutiepie]

Yep, this is one of those that didn't transfer over. Here the outline is in DST format.